Company News

News

Company News

Engineering concrete mixing station parts lubrication maintenance

2018-06-27 11:01:20

In order to achieve good lubrication of parts in engineering YHZS75 concrete mixing station, it is necessary to pay attention to the following points:

1) according to the provisions of the lubricating specification for parts of the ready mix concrete plant, add the lubricating oil with appropriate viscosity on each part of the mixing station on schedule and on time.

2) the amount of lubricating oil must be sufficient, and the oil layer added into the oil tank or oil pool should reach the water indicated by the buoy. The amount of oil added to the high speed rotating rolling bearing should be appropriate, not too much or too little, or it will get hot and damaged.

YHZS75 mobile concrete batching plant

3) the lubricating oil must be very pure and clean, and there shall be no impurities, dust, moisture and mud, so as to prevent damage to the lubrication effect and the surface of parts of the concrete mixing station.

4) the lubricating oil in the oil tank and oil tank shall be replaced regularly according to the specifications of parts in the mixing station. When changing oil, you must clean the oil pool with kerosene.

5) the oil hole, oil block, etc. must be kept closed to prevent the invasion of dust, abrasive dust, and concentrated cooling.

Related articles
Online message
    Message
    Online Customer Service