With the country’s attention to the environmental protection of mobile concrete batching plants, many manufacturers and users nowadays also attach great importance to the dust pollution of 75ready mix concrete plant, so how to accurately solve the problem of dust in the concrete mixing plant.
1. Accurately plan, arrange and rationally select dust removal equipment. Install the duster directly on the inclined belt head cover. All the air ducts are also connected to the inclined belt head cover, which provides a space for the dust blown by the air duct to settle, which is effective for reducing the amount of dust directly entering the dust collector. Then, a pneumatic butterfly valve automatically controlled by the operating system of the YHZS75 concrete mixing station is installed in the lower mouth of the dust collecting hopper of the dust collector.
2. The dust removal equipment should be carefully viewed and protected. The operation of the dust collector of the cement silo dust collector is very important, and the customers of the wide concrete mixing plant usually do not know its importance. When the dust removal effect is found to be poor, the safety pressure relief valve starts to ash, the dust collector is now filled with dust. At this moment, it is only too late to start the vibrator to remove the dust on the filter. The foundation does not work. Therefore, each shift must check whether the dust collection pipes are dusty, because the non-straight dust removal pipes are easy to block. Regularly check the dust collection status of each dust collector filter. If necessary, disassemble and clean the filter element. Accurate and rational planning, layout and selection of dust removal equipment can not only ensure the overall quality of the mixing station, but also reduce the cost of use and protection. Very important meaning.