Ten points for attention in the production process of brick making machine

1. When the brick making machine is not in operation, it is forbidden to start feeding tissue to prevent the appearance of the billet parts from being damaged due to overload. The direction of electric motor is forbidden to stand people.

2. It is necessary to install all protective cover and floor cover when the machine is operating.

3. If concrete block making machine is found to be abnormal, it shall immediately park and check the cleaning.

4. Check some electrical grounding wires to prevent leakage, short connection and other appearances.

5. The use of cement brick making machine environment is relatively poor, so mechanical wear all sorts of problems more outstanding. In principle, please organize the normal protection and protection according to the production status.

6. If oil cylinder, valve block, valve parts, tubing and other hydraulic parts show oil leakage, we should choose to replace oil seals, sealing rings and other repair methods or the whole piece replacement to prevent the operation with diseases.

7.The ambition is below 80 ℃ to ensure the hydraulic oil cooling, water cooling system shall not be less than 8 cubic meters, the cooling water flow rate shall not be less than 18 cubic meters/hour. Ban use unqualified plate, so as to prevent damage of jam the machine

8. Some of the parts shall be smooth according to the smooth requirements of the general machine. The oil surface of the oscillation box and the smooth liquid oil surface shall not be higher than the lower end face of the eccentric axis

9. Clean the oil extractor and oil return filter as scheduled by using foaming additives and qualified hydraulic oil products with good viscosity, and filter the oil at least once a year. Always check the tank to practice the amount of oil, if necessary

10. The vibration pressure time of the product shall be strictly controlled, and the vibration time shall be adjusted according to the product demand, and the optimal proportion shall be summarized between the production rate and the quality, and the feeding quantity or feeding times shall be adjusted to reach the balance if necessary.