Operation rules for a concrete mixer pump

Operation rules for a concrete mixer pump are as below.

1. The operator must be well trained and qualified enough before being employed.

2. It’s forbidden to run a pump in roads with traffic. Construction warn signs and enclosure panels must be placed around the pump working area, and other traffic rules in local regions must be followed strictly as well.

3. No cleaning, oil-refilling or adjusting of the pump is allowed with a pump in operation.

4. The operator shall not leave the pump alone before turning off the power and taking off the key.

5. Keep words of safety rules and instruction signs on the concrete pump clear and clean.

6. No modification of safety device of the pump shall be allowed.

7. Pay close attention to the tire pressure all the time.

8. All operators and relative staff shall wear safety caps and follow safety rules.

9. No unrelated people shall be allowed into working area of the pump.

10. After each round of pumping, the operator shall check carefully whether there are impurities or water in the material bucket or the water tank.

11. Reliable signal by gesture should be kept between the pump and the construction site.

A concrete mixer pump can be efficient and cost saving if you use it properly, yet it brings lots of trouble once you neglect operation rules. In addition to rules mentioned above, you should also pay attention to possible pipe clogging in operating a concrete mixer pump. If you have any problem in your operation, welcome to contact us!