Check matters of HM8-D concrete mixer truck

1. Careful inspection, timely detection and troubleshooting

1) Do not overload concrete mixer truck on the road, otherwise it will be troublesome of the tank, the concrete can not be stopped for more than 2 hours, and the C40 or concrete up to the level concrete can not stop mixing.

2) Check engine oil, antifreeze, lubricating oil and cooling water before ignition. If it is insufficient, it should be added again.

3) After HM8-D concrete mixer truck is started, let the can rotate at a low speed, check the tire pressure around the cement mixer truck, whether there is a leaking tire, and then use a screwdriver to remove the stone in the seam and check.

4) Ensure there is not a nail stuck in the tire!

5) Check the lights again, especially the waist lights. Make sure that the tires are often stacked on the construction site, and the tires are always the most weak part.

6) Wipe the rear view mirrors on both sides with a rag and window glass, complicated road conditions on the construction site with poor lighting, so the line of sight must be guaranteed first!

2. Ensure that there is enough water in the water tank and there is a water reducing agent

For various reasons, the raw material is too dry. When there is no water to add or discharge, the water reducing agent is a life-saving straw.

3. Confirm that the mixing tank is in a stopped state

For the can is in a high-speed rotation state when the engine is started, the instantaneous force will be very large, and the reducer will be injured.